3PCS Table Inserts for 14″ Band saws or Scroll saws（Diameter: 2.5 in, Thickness: 0.1 in），replace Part 426-02-063-0001 426-02-063-0002

use on 14″ Band Saws and 24″ Scroll Saws.Table Inserts (pack of 3). Material: Aluminum
They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
Make sure your insert recess has the locating pin on the side , not on the rear
IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
Please measure your saw as some Delta & Rockwell 14″ bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required
use on 14″ Band Saws and 24″ Scroll Saws.Table Inserts (pack of 3). Material: Aluminum
They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
Make sure your insert recess has the locating pin on the side , not on the rear
IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
Please measure your saw as some Delta & Rockwell 14″ bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.