RATTMMOTOR 1.5KW VFD 110V Single to 3 Phase Inverter Variable Frequency Drive Spindle Motor Controller Converter 0-1000Hz + Extension Cable for CNC Router Milling Engraving Machine

Product Description

RATTMMOTOR 1.5KW 110V VFD

Frequency range: 0-1000HzAccuracy: 1) Digital type: 0.01％(-10～40℃); 2) Analog type: 0.1％(25±10℃)Setting resolution: 1) Digital type: 0.01Hz; 2) Analog type: 1％ of the maximum operating frequencyOutput resolution: 0.01HzKeyboard setting mode: Set directlyAnalog setting mode: External voltage 0-5V, 0-10V, 4-20mA, 0-20mAOther Ductions: 3 hopping frequencires (lower-frequency limit, start-up frequency and stop frequency) can be set respectively.Control Mode: V/F Vector ControlCommunication Control: RS-485Vibration: Below 0.5G

Description of jumper fuction: J1: Selection of X1-X6 wiring mode: NPN PNP ( Ex-factory setting: PNP) J2: Selection of AO output: VO, voltage AO, current ( Ex-factory setting: VO) J3: Selection of AI2 input: V, voltage A, current ( Ex-factory setting: A) J4: RS485 communication interface terminator enabled: ON OFF ( Ex-factory setting: OFF) J5: Selection of X6 terminal fuction reuse: X6 Y1-PEO ( Ex-factory setting: X6)

Variable Frequency Drive

Power: 1.5KWInput Voltage: 110V(+/-15%)Output Voltage: 110VACInput Frequency: 50-60 HzOutput Frequency: 0-1000 HzInput Phase: 1 phaseOutput Phase: 3 phase

SHIFT: Status monitor mode switch, parameter of third stage menu switch.DIR: Change the running director of motorESC: Return to the starus of “ENTER”UP: Parameter of fuction code, data increase, revise and select all kinds of modesRUN: Run commandSET: Enter into menu, enter into parameter or parameter date writing confirmDOWN: Parameter of fuction code, data decrease, revise and select all kinds of modesSTOP: Stop command / abnormal commandSPEED: Speed controller

Description of main circuit terminals:

L / N: Input power terminal, connected to singe-phase powerU / V / W: Input output terminal, connected to three-phase motorDC+ / DC- : DC output + terminal, DC bus output terminal is used for connecting external brake unit or common DC bus system.DB: Brake output terminal, connecting brake resistor between DB and DC+PE: Earthing terminal, inverter housing earthing terminal must be earthed.

Specification of Protection Control:

Overload protection: Electric relay protection motor driverFuse protection: In case of fuse, the motor stops runningOver voltage / Low voltageRestart after transient stop: Restart after transient stop through frequency tracking modeStall prevention: Stall prevention during acceleration/decelerationShort circuit of output terminal: Electronic protectionOverheating protection of ridiating finOther fuctions: reverse limit, direct startup after operating, fault reset, parameter locking, ect.

Basic wiring diagram

Inverter wiring involves main circuit and control circuit. The user can raise the cover of housing, at this time main circuit terminal and control circuit shall be viewed, and the user conduct correct connection as per wiring circuit below.

Description of Control Terminals

Fault Information and Fault Clearing

Input Voltage: 110V(+/-15%); Output Voltage: 110VAC.
Input Frequency: 50-60 Hz; Output Frequency: 0-1000 Hz.
Input Phase: 1 Phase; Output Phase: 3 Phase.
Suitable for 0.8KW or 1.5KW 110V CNC air-cooled water-cooled spindle motor.